Dynalink WLG25USB Guide d'installation télécharger pdf (Page 8)

Uninstalling the adaptor, driver and utility

6.1 PERMANENT REMOVAL

The correct procedure is to uninstall the software first. You will then be advised

to physically remove the adaptor.

To uninstall:

1. Close all programs that are currently running.

2. Click the Windows Start button, point to All Programs > RaLink > RT2500

and select Uninstall.

3. Follow the on screen instructions to proceed with software removal.

6.2 TEMPORARY REMOVAL WITHOUT UNINSTALLING DRIVER AND SOFTWARE

It is recommended that you follow the standard Windows procedure for removing

a device from your computer.

1. Double click the Safely Remove Hardware icon on taskbar.

2. Select the device you want to remove, click Stop and then OK.

3. Wait for the safe to remove message is displayed, click OK and remove device.

Troubleshooting

1. Cannot connect to access point (infrastructure mode) or

other wireless stations (ad-hoc mode)

Check that the correct install procedure was followed and the wireless utility

displays the network you wish to join.

Make sure the adaptor and access points/wireless stations are using the

same SSID.

If MAC address filtering (section 5) is enabled at the access point, contact the

network administrator to include your adaptor’s MAC address into the list of

authorised clients.

If encryption is used, make sure the encryption parameters entered match

the access point. Contact the network administrator if you are unsure.

Restart computer.

2. How to find the MAC addresses of my adaptor

The MAC address of your adaptor can be read off from a barcode label affixed

on the product.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Dynalink WLG25USB Guide d'installation Page 8