Dynalink RTA1025W Guide d'installation télécharger pdf (Page 32)

Enabling Wireless Zero Configuration

Some wireless adapters have a 3rd party utility installed which controls the configuration and

connection profiles of the wireless adapter.

In these cases, it is necessary to enable a service called "

Wireless Zero Configuration". The

steps to do this are listed below:

1. Click on the Start Menu. Click on “

Run”, and type: services.msc <and then click

“

OK”>.

2. Scroll down to the bottom of the list and locate the service called "

Wireless Zero

Configuration

" and double left click on it.

3. Change the "

Startup type" to “Automatic”, and then check the "Service status"

below this;

- If the “

Service status” is “Started”, click “OK”.

- If the “

Service status” is “Stopped”, press the “Start” button on the lower left

side of the window and then wait until the service has started. When it has, click “

OK”.

4. Close the Services window.

1 2 ... 27 28 29 30 31 32

Pas de commentaire

Dynalink RTA1025W Guide d'installation Page 32