Dynalink RTA1025W Guide d'installation télécharger pdf (Page 8)

3. Click on the "Wireless Networks" tab, as shown below.

(If you do not see this tab, you will need to enable and start the “Wireless Zero Configuration” service.

Please refer to the steps

at the end of the guide to enable this)

Make sure "Use Windows to configure my wireless network settings" is TICKED.

This window will list any wireless networks you have previously connected to. If you see an

entry matching the

SSID you obtained at the start of this guide, you will need to select it and

then click "

Remove".

(Typically, a number of networks will be listed here. This is nothing to worry about. You can

delete the other entries too. These are just stored settings and passwords for connecting to

the listed networks.)

If your

SSID is not listed, or you have just removed it, click “OK”.

The window will close and you should now be returned to the “

Network Connections” control

panel window.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Pas de commentaire

Dynalink RTA1025W Guide d'installation Page 8